Posted: Fri Aug 04, 2006 10:30 pm
Nobody wrote:madjack wrote...we had built our doors with a 1/4 gap using the same considerations that you did...when we did the dry fit we found that we needed 5/16 to keep from having clearance problems.
Jack, did you use the 5/16" gap measurement all the way around or just make the doors 5/16" smaller total ? Thanks
...that was a 5/16th(total) all the way around...since we started out with a 1/4" gap, we took 1/8th of the bottom and one side and sanded of the corner radius to match back up...this gave us a 5/16th gap all around..
madjack
p.s....let me say one more thing...dryfitdryfitdryfitdryfitdryfit and then dry fit again until you are absolutely sure of the fit before doing anything permanent