tire clearance

Anything to do with mechanical, construction etc

tire clearance

Postby Chip » Mon Jun 21, 2004 12:12 pm

:?: does anyone have specific data,,, experience or just a good educated guess as to minimum clearance between the tire and the teardrop wall ,,mine is a bit tight. it may be ok ,,just need some advise,,thanks

chip
Living large,,,travling small !!!
54"x9'4" tear
4'x8' tear
Serro Scotty rebuild(in progress)
User avatar
Chip
2000 Club
2000 Club
 
Posts: 2534
Images: 49
Joined: Sat Apr 17, 2004 7:33 pm
Location: Greenville, S.C.

Postby Shrug53 » Mon Jun 21, 2004 12:18 pm

I do not think the clearance from the wall is nearly as important as the clearance from the top.
Until recently I was running 14x8 rims on my 53 Chevy and there was less than 1/4" clearance between the tire sidewall and the lip under the back fenders. Never had a problem as there is no sideways motion to speak of
I would say if you have an inch of clearance you would be fine.
Again this comes from my experience building hot rods, so I am not absolutely sure if the same rules apply to trailers.
"Better living through reckless experimentation"
http://www.forgottenclassics.com
User avatar
Shrug53
500 Club
 
Posts: 546
Joined: Tue Jun 08, 2004 9:17 am


Return to Teardrop Construction Tips & Techniques

Who is online

Users browsing this forum: No registered users and 35 guests