I routed a rabbet on my wall frames and then was going to glue on the interior skin (1/8" Lauan). Problem is, how to trim the skin back to match the rabbet on the walls. My trim bit with bottom bearing will not fit in the 3/8" rabbet with the screw holding the bearing sticking out. I don't have a trim bit that will follow a 3/8" rabbet depth...
Trim bit needs 1/2"+ to follow with bearing...
I know I can follow the rabbit the with the router guide fence and straight bit as shown above, but, I don't know if the straight bit I used will cut through the 1/8" without trimming it close first. And how would I do that rough cut.
Help! I'm beginning to experience thoughts I need to rebuild the wall frames...