...Indy it is a pretty well engineered piece of Al extruson in two parts...the two parts mount solidly to the table and wall and lock together in way that will not allow them to come apart unless the far end of the table is raised quite a bit...
...of course you haveta have a leg on the opposite end...we plan on using 1/2"EMT and flattening/bending one end which will attach to a T nut or insert on the bottom of table and pin to a small bracket to the side of the trailer, eliminating the need of an adjustable leg...the leg/struts will be powder coated...
...the two tables we have are 12 and 15"s wide X ?? long because that is the scrap we had left over in those sizes, we will attach a 10" long piece to the end of each and have no fear about it being stout enough to hold an ice chest or stove witha full dutch oven sitting on either of them
madjack