So I am stilkl ironing out the materials and plans for my camper / cap build. The concept as I have stated before is the bed will be a folding unit, sideways across the bed of the truck over the bed rails, and will be when set up king sized. The cap will provide at least 6' 2" headroom so I don't have to stoop for my back, and there will be a section at the back that acts as a slide out when the tailgate is down that will house the door, have an AC mounted in the wall, and will have a 5 gallon port o potty slide into place for night time loo usage instead of traipsing outside of the camper...
For cost and simplicity sake, I want to use my existing 6 gallon Reliance AquaTainers for my fresh water supply. I have 4 of them, and am trying to figure out a way to use one common pickup and fill for the tanks, or would I simply be better off using one pickup and make sure it's easy to swap between tanks?
Filling in the truck isn't so much a concern. One of the reasons I want to be able to use these is the ability to take the tanks out of the truck to fill them individually. They will be retained in the truck FYI under the bed by the bed frame cross bars. There is more than enough room there for it all...
I want to provide in the camper water for cooking / wash up during foul weather, and outside hte camper water for cooking, cleaning and showering for fairer weather...
Anyway, any ideas, and preferably photos of effective multi aqua tainer or similar systems would be greatly appreciated, especially how you make the penetration through the cap and keep it sealed!