Re: FoamStream...
Posted: Wed May 09, 2018 4:55 pm
The window is so large , we’re going to make a full size template for marking , cutting the hole , and making the inside window trim . I think i can just fit it between ribs . leaving two in the center to cut away
This window is Used and the many outer frame screw holes were really tightened down, enough to distort the metal frame around the hole ( Cone’d ) … We tried using a really big C clamp and tightening it down , but that was slow ( and tiring ), and we finally resorted to a small ball peen hammer backed up with a small sledge hammer as a dolly … couple light taps did it … Nice and Flat again … like new … ish’
This window is Used and the many outer frame screw holes were really tightened down, enough to distort the metal frame around the hole ( Cone’d ) … We tried using a really big C clamp and tightening it down , but that was slow ( and tiring ), and we finally resorted to a small ball peen hammer backed up with a small sledge hammer as a dolly … couple light taps did it … Nice and Flat again … like new … ish’