Re: Working with flashing and beading
Posted: Sat Dec 13, 2014 10:51 pm
So now I have a nice square to fit into the vent hole on the roof. This will hold everything nice and square and give a edge to screw or pop rivet the roof vent to once installed.
One thing that is very important in installing the flashing is that you want to make sure you have no spots in you cutout/surface that is not true. You want the flashing to fit but not be pushed by it's surroundings. If it does not fit relaxed it will buckle or lift due to some stress from a tight spot in the cutout.
Install and check for a nice clean fit.
One thing that is very important in installing the flashing is that you want to make sure you have no spots in you cutout/surface that is not true. You want the flashing to fit but not be pushed by it's surroundings. If it does not fit relaxed it will buckle or lift due to some stress from a tight spot in the cutout.
Install and check for a nice clean fit.