6'6 wide inside x 6' tall inside x 7' long
T&G the 4' sheets or possibly tenons to get the larger sizes
1/2" treated plywood bottom adheared to 2" foam floor with linoleum flooring(? ) as the camper will be used in deep snow and wet very often.
2' foam for structure, canvas exterior, shower type thin lining on interior walls and ceiling again because of deep snow and wet often.
GG for glueing foam structure
TBII for canvas hoping will be ok for snow
prebuilt door & window (?) No roof vent but can crack door window or regular window for air
Heavier metal angle frame around bottom for attaching to pick up flat bed, small trailer (already own), custom skied sled for pulling through deep snow
No hatch
Instead of kerfing, thinking possibly building a roof form, attaching the front roof section to the sides, then placing a shop heater inside blowing right at the top foam pieces and SLOWLY shaping it to the form???? Again just thinking at this time!!!!
All critique welcome.