Moderator: eaglesdare
JazzVinyl wrote:Now have to wrangle that "Elastomeric Roof Coating" for the bottom....
ghcoe wrote:When I did my floor I just rolled the body onto it's side. I used some left over foam strips to support the body to keep it from getting damaged.
JazzVinyl wrote:A little more progress...
Skewers hold it until the glue dries:
Pretty soon, I will be fresh out of excuses not to get the exterior canvassing done!
And oh my, the acoustics inside, are sooooooooo nice!!
.
JazzVinyl wrote:ghcoe wrote:When I did my floor I just rolled the body onto it's side. I used some left over foam strips to support the body to keep it from getting damaged.
Thanks George...
How did you attach the drip edge?
Sparksalot wrote:Skewers hold it until the glue dries:
The skewers are a novel idea. Looking good!
ghcoe wrote:Paint the body and coat the bottom of the floor first. I then use L Trim Corner Bead https://www.homedepot.com/p/Gibraltar-B ... /202948027 and use Sharp Point Lath Screws https://www.homedepot.com/p/Teks-8-x-1- ... /100150464 to attach it to the floor. I also apply caulk to the body before installing the beading to create a water tight seal.
GPW wrote:We used George’s drip edge idea on the FoamStream and it works PERFECTLY …
GPW wrote:Looks Good !!! Nice termination !
Users browsing this forum: No registered users and 17 guests