by JMailbox8 » Sun May 05, 2024 2:27 pm
I am planning to put aluminum corner trim around the outside of my filon skinned squaredrop camper. In order to eliminate or reduce screws, I was thinking of placing Eternabond Doublestick or 3M VHB tape over the corners to seal my edges, then use a roller to really work the material to the surface, pull back the peel, then stick my corner trim over the tape and press on hard. If needed, I could put screws in at the ends. The trim is black, so concern about the sun heating the trim and adhesive may be real. I have never used these products before. Does anyone have any experience with this application that could give their thoughts on my idea? Good, bad? I just want to limit water intrusion by the screw holes. TIA.