Got back from Lufkin trailers in San Antonio with my aluminum. I got one continious roll of sheet metal 18ft long and 102in wide.
My question is, How did you cut it without having to walk on it?
The entire drive back, I was thinking about it. I think I have a plan, maybe you can tell me if it will work.
I am going to get 2 2X4X10s and run 2 carraige bolts thru them. I will stick one inside the roll and one outside and clamp the roll by tightening the bolts. Then I can cut off a piece by standing behind the roll. I can add another "Clamp" and loosen the first one so I can pay it out without releasing the tension on the roll. I'm also afraid of the entire thing springing open if I cut the band.
Am I being too parinoid about this whole thing?