I am finishing up the finish of my build. I used RAKA UV epoxy over all exterior surfaces and on the galley floor and counter. after about a week, then I covered that with MINWAX Spar Urathane. all is well with the walls.
I got a little ahead of myself as I was using the last of my epoxy on the galley. I had already started urathaning over cured epoxy on the floor, but I needed to add some more expoxy to the rear edge as waterproofing. I inadvertently overlapped some fresh epoxy and fresh urethane over about a 2 inch strip. it appears that it is not curing properly. a week later and I still have a strong smell and a slight tacky feeling at that strip. the rest of the floor (urethane), and the rear edge (epoxy) all cured since then.
so what do I do to clean up this mess that I am guessing will never cure? last night I tried rubbing it down with paint thinner. I will see if that helped tonight after work. if it didn't, what should my next step be?