So after looking around and reading everything I could on skins to use and how to install it I finally took the leap and started to skin my teardrop! I ordered two sheets of white 5mm UV resistant frp from a local building supply store. (Incase anyone is interested I paid $50 a sheet) I also bought some gorilla glue exterior high strength multipurpose glue ($4 each).
I then sanded the whole side wall and wiped off any dust with a rag, I then applied the glue covering the whole wall. My wife and I lifted the panel into place careful not to touch the glue until it was in place. Once we got it situated I stapled the first corner and started to push the panel to the wall, working from rear to front and stapling as I went. I used a router with a bearing tipped cutter I cut the front and rear curves, then from the inside I drilled a hole big enough for the router bit and using the router on the outside I cut the door out. I’ll probably be up doing the same on the other side.
I still need to ores the frp for the roof and order the trim, but here’s some pictures of my progress so far.