Hi folks,
I am about to start 'final fit-hinge mount for my doors--doing piano hinge, surface mount. I am looking to get 1/8" clearance between door and wall all the way around. I am not planning to add any luminum trim or any thing like that at this point. So, what I am saying is that if you measured the clearance between the door and the wall at any point, top, bottom, sides there will be a 1/8" gap....allowing for some adjustments in process.
IF I decide to add trim later to either the door or the wall opening, I will dismount the door and sand off some more....
Once doors are spotted, I can actually begin putting the walls up etc!
Have been doing an unbelievable amount of sanding and varnishing on ceiling ply, interior walls etc...3 coats on everything....
Annnd.... we cut the curve on the hatch into an even more open configuration.....will send pics when I get the walls up..
the decision to adjust the curve came from the dry fit of the walls...
Hope this is a good day for everyone,
Jim