I have been bothered by my fender mounts for nearly a year. I re-used the "stock" bracket along with my cool fenders. That left the fenders about to wiggle and vibrate, swing in the breeze. Not ideal.
I've challenged myself all along to re-use and recycle as much of the original frame as possible. I had two 6 inch pieces of angle iron left from the caster mounts. So I cut them up and started whatiffin'.
Proof of concept shot. Note specialized work light. It was a cheap trade show gimme cap bill light.
Left front after bolting in place.
Left rear. Note tire scuff on the original "main" bracket. I bought the axle and wheel upgrade. The bracket was not replaced by mfr.
This will bear watching.
Views from above. Pretty low key really. Stiffness Quotient has gone much higher.
At the rear edge is the frame mount for the casters. I still have ideas swirling for those. Flagpole mounts? Antenna mast for the HF radio? They'll get used somehow.
Doesn't everyone have this much working room?
Finally, a tip of the hat to Hubcap Mike's and his Moon Discs. These wagon wheels take Rose to Dork Factor 10 in microseconds.