Joiner trim for diamond plate

Finishes, paints and coatings

Joiner trim for diamond plate

Postby daneyuleb » Tue Mar 21, 2017 11:59 am

Like an idiot, I messed up the cut on the 16 gauge diamond plate I'm trimming for the bottom 9 inches of my TD with, so now instead of one long piece on one of the sides, looks like it will need to be 3 pieces.

Anyone have any recommendations for what vertical trim to use between the pieces to hide the seams where they butt up? The middle section will be about a 5 inch high by 20 or so (under the door) so I won't need much--just worried standard aluminum trim won't properly seal over the diamond-protrusions. Any special considerations when joining diamond plate vs smooth aluminum?
daneyuleb
Teardrop Inspector
 
Posts: 13
Joined: Mon Mar 20, 2017 4:57 pm

Re: Joiner trim for diamond plate

Postby M C Toyer » Wed Mar 22, 2017 11:13 am

Have you thought about grinding down the protrusions where the trim will overlap? That way the top of the trim will be about the same height as the entire sheet.

Don't know if you are able to source a simple T mold to match the diamond plate but leaving a suitable gap between the diamond plate sheets for the leg of the T will keep the piece from warping / curling. Your can seal the trim to the diamond plate with putty tape which will be hidden.
User avatar
M C Toyer
The 300 Club
 
Posts: 363
Images: 11
Joined: Thu May 31, 2012 8:59 pm
Location: Pilot Point (Denton County) Texas

Re: Joiner trim for diamond plate

Postby tony.latham » Wed Mar 22, 2017 12:28 pm

I ground the diamonds down using an angle grinder for this chip protector. It looks really good until you get really close. :shock:

Image

I would consider sealing the cr@p out of it with a good poly sealer (and epoxying the underlayment) and butt jointing unless you can figure out a way to accurately mill off the protrusions. The other thought is T-moulding with a sealer to fill in the gaps above the diamonds––I think that'd look okay.

Tony
User avatar
tony.latham
Gold Donating Member
 
Posts: 7011
Images: 17
Joined: Mon Jul 08, 2013 4:03 pm
Location: Middle of Idaho on the edge of nowhere
Top

Re: Joiner trim for diamond plate

Postby daneyuleb » Thu Mar 23, 2017 2:10 pm

Actually I didn't think about grinding 'em down. It's such a small piece, that may be doable.

I did find something here that looks promising though, so I may go that route. A bit pricey with shipping for the small amount I need though...

http://diamondlifegear.com/trim.html

Joiner
HE94
slides on to cover seam
1/16" opening (0.063")
non-returnable
click for dimensions
daneyuleb
Teardrop Inspector
 
Posts: 13
Joined: Mon Mar 20, 2017 4:57 pm
Top

Re: Joiner trim for diamond plate

Postby tony.latham » Fri Mar 24, 2017 4:40 pm

You might toy with grinding most of the diamond off and building a slotted router jig to make a clean cut for T moulding to fit into. I think this might work. I've trimmed a several yards of .040 sheet but nothing like this with a router.

:thinking:

Tony
User avatar
tony.latham
Gold Donating Member
 
Posts: 7011
Images: 17
Joined: Mon Jul 08, 2013 4:03 pm
Location: Middle of Idaho on the edge of nowhere
Top


Return to Skinning secrets

Who is online

Users browsing this forum: No registered users and 8 guests