Looking for a little input from the group.
Not to keen with the fender brackets on the NT trailer, kind of need to take a hammer to them to get the fenders to sit level and well, they are just kind of cheap and ugly
I could fab up something a bit cleaner/stronger but seeing I'm building out over the fenders I'm thinking of ditching the brackets and bolting the fenders to the bottom of the floor with some 1/4" stand off's so they aren't in direct contact so things can dry out under there and not rust out the fenders. Figure I can put in some Tee-nuts before closing in the floor, pump the holes full of silicon as I run in the bolts to seal them up.
I'm open to suggestions and brilliant ideas.